Заказать и купить изделие « Пускатель магнитный ПАЕ-612» от производителя в Спб, Москве.

PAE-612 magnetic starter of the sixth magnitude, open, with a thermal relay, without reverse, degree of protection IP00, rated current 146A at a voltage of 380V, designed for remote starting and stopping of three-phase asynchronous electric motors with a squirrel-cage rotor operating in moderate climates at rated voltage up to 380V, frequency 50Hz, ambient temperature from minus 40 ° to 40 ° С.PAE-612 starters can also be used to control any electrical loads - DC motors, electric furnaces, heaters, asynchronous motors in the power range from 1.1 to 75 kW for a voltage of 380-660 V. The starters have a switching capacity of up to 2,000,000 on-off cycles. The choice of starters is carried out according to the rated voltage of the network, the rated supply voltage of the coils of contactors and starters, according to the rated switching current of the electrical load. PAE-612 starters are characterized by high reliability, low power consumption and heating, good overload capacity and therefore can be used to start electric motors with severe operating conditions and a long acceleration period and a set of rated speed. During a long acceleration of the motor, the current consumed by it is much higher than the rated current, which not only leads to additional heating of the motor, but also creates an increased load on the main contacts of the starter. PAE-612 technical characteristics Rated current at voltages of 380V - 146A Rated current at voltages of 500V - 80A Maximum switching current at voltage 380V and cosφ = 0.4 - 1500A Rated power of the starter coil PAE-612 - 38 VA Starting power of the coil - 3400 VA Starter coil power supply - 110V; 127B; 220V; 380V Overall - 380x230x190 mm Open version (unprotected). Overload protection - there are protective thermal relays TRN, PTT or RTL Degree of protection PAE-612 - IP00 Starter weight - 103 kg Maximum power of the connected motor - 75 kW Normal operation of PAE-612 starters is allowed at a voltage at the terminals of the main circuit up to 1.1Un and control circuits from 0.85Un to 1.1Un of the rated voltage of the corresponding circuits.